2009-11-22

This project is about replacing the Volvo Flygmotor Water heater, the reason for replacing it is that is too large and not insulated, if I would insulate it it would take too much space

Inserting some pics, I will come back with installtion tip later in the progress.

This is a picture taken at my first inspection, september 2003, the engine room had a dreadful look..

This picture is tke n with my mobile, the light from the head lamp was a little poor, it is of 15 litre capacity ant the manufacturer is Isotemp, I will give you more facts later as well.

This is hpw it looks inside, its from a retailer.

Here is a better one, this project will be resting now until spring (maybe that I will install a 220 Volt outlet just below the Heater so I dont need to cut the power cord)....

2009-11-25

Installed a double power outlet Class IP 54 (5 means protected agains dust and 4 means protected against drizzling fluid)